48483697_ed6
EN-1
EN
Product Safety Information
Intended Use:
These die grinders are designed for grinding, porting, polishing, de-burring, and breaking sharp edges.
For additional information, refer to Air Die Grinder Product Safety Information Manual
Form 04580288.
Manuals can be downloaded from ingersollrand.com
Product Specifications
Model(s)
Free Speed
Collet Size
Sound Level dB(A)
(ISO 15744)
Vibration (m/s²)
(ISO 28927)
rpm
† Pressure (L
p
)
‡ Power (L
w
)
Level
*K
5102MAX
20000
1/4"
84.1
95.1
3.3
1.1
5102MAX-M
6 mm
5108MAX
25000
1/4"
83.3
94.3
1.8
0.8
5108MAX-M
6 mm
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
*K = Vibration measurement uncertainty
WARNING
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain condensate
from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air
Fuse upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to
prevent hose whipping if a hose fails or coupling disconnects. MAX Series Die Grinder vanes are made of
a special material that does not require constant lubrication. However, we do suggest periodic lubrication
for optimum service life. See drawing 16573164 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
6.
Thread size
2. Regulator
7.
Coupling
3. Lubricator
8.
Safety Air Fuse
4. Emergency shut-off valve
9.
Oil
5. Hose diameter
10. Grease
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest
Ingersoll Rand
office or distributor.
