EN
47582172001_ed2 EN-1
Product Safety Information
Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information, refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.
Power Management System
For models that include a power management system, the system allows operator reduction of maximum output power.
To adjust the power, rotate the Power Regulator to the desired level indicator. The power level indicators are for reference and DO NOT indicate
a specific power. The power output can be further reduced in forward or reverse by using the variable throttle.
Product Specifications
Models
Style
Drive
Impacts
per Min.
Recommended Torque Range
ft-lb (Nm)
Type
Size
Forward
Reverse
2850MAX
Inside Trigger
Square
1”
770
2000 MAX
(2715) MAX
2100 MAX
(2850) MAX
2850MAX-6
Inside Trigger
Square
6” extended
1”
770
2000 MAX
(2715) MAX
2100 MAX
(2850) MAX
Models
Impacting Sound Level dB(A)
(ISO 15744)
Free Speed Sound Level dB(A)
(ISO 15744)
Vibration (m/s
2
)
(ISO 28927)
† Pressure (L
p
)
‡ Power (L
w
)
† Pressure (L
p
)
‡ Power (L
w
)
Level
*K
2850MAX
96.7
107.7
105.0
116.0
12.6
3.6
2850MAX-6
96.7
107.7
105.0
116.0
10.3
1.9
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
* K = Vibration measurement uncertainty
WARNING
Sound and vibration values were measured in compliance with internationally recognized test standards. The exposure to the user in
a specific tool application may vary from these results. Therefore, on site measurements should be used to determine the hazard level
in that specific application.
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air filter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling disconnects. See drawing 47132790 and table on page 2.
Maintenance frequency is shown in a circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
5. Hose diameter
9. Oil
2. Regulator
6. Thread size
10. Grease - during assembly
3. Lubricator
7. Coupling
11. Grease - through fitting
4. Emergency shut-off valve
8. Safety Air Fuse
Parts and Maintenance
When product life has expired, it is recommended that the product be disassembled, degreased and parts be separated by material for proper recycling.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.
