WebPOS iWP220/ iWP250_user guide
•
4/20
Copyright © 2009 Ingenico
9000002528 R11 000 01/926
All rights reserved
3.
Recommendations
3.1.
Security
Power on/Power down
To power on or power down the iWP220/iWP250 connect or disconnect the power supply
from the electric outlet.
Lithium battery
The iWP220/iWP250 is fitted with a lithium battery, which is not accessible to the user. Only
a qualified technician may be authorized to open the unit and change this component.
Electrical power supply network
Provide an electrical outlet:
- located near the equipment and easily accessible
- which meets the standards and regulations in the country of use.
- The terminal iWP can be connected to a power distribution system of the IT type.
Cable shield cover
The cable shield cover is located under the terminal (see chapter “4.5
Installing the
iWP220/iWP250 – Cable fixing”) must be in place during normal operation of the terminal.
3.2.
Security of your terminal
Upon receipt of your terminal you should check for signs of tampering of the equipment. It
is strongly advised that these checks are performed regularly after receipt. You should
check, for example: that there is no evidence of unusual wires that have been connected to
any ports on your terminal or associated equipment, or any other part of your terminal.
Such checks would provide warning of any unauthorized modifications to your terminal,
and other suspicious behavior of individuals that have access to your terminal.
You are strongly advised to ensure that privileged access to yours is only granted to staff
that have been independently verified as being trustworthy.
3.3.
CE standard compliance marking
CE standard compliance marking certifies that the product stipulated below:
iWP
.
•
complies with the basic requirements of European Directive 1999/5/CE, known as the
«
R&TTE Directive
» concerning Radio Frequency equipment and telecommunications
terminals with respect to:
–
Health and safety protection of the user and all other persons
–
EMC protection
•
conforms to the following harmonized standards :
–
IEC/EN 60950-1: Electrical safety of data processing equipment including electrical
office equipment. Issue dec 2001
–
EN 55022: Data processing equipment – Radioelectric disturbance characteristics -
Limits and measurement methods. Issue 1998 / A1-2000/A2-2003
–
EN 55024: Data processing equipment – Immunity characteristics - Limits and
measurement methods. Issue 1998 + A1- 2001 + A2- 2003
•
complies with the following specification:
–
EN 301511 : Harmonized stand for mobile
–
EN 300328 : (BT + WLAN) Electromagnetic compatibility and Radio Spectrum
–
EN 300330 : NFC Electromagnetic compatibility and Radio Spectrum
