Loading fastener and operation
WARNING
:
Always disconnect the tool from the compressed air before loading. When
loading the tool always point the tool away from yourself and others. Make sure that you are not
holding the tool with trigger depressed while loading the tool.
1. Insert a strip of fasteners into magazine keeping it point down.
2. Release the latch and pusher, slid the pusher against the nails.
3. Connect the tool to the air supply. Make sure the air pressure is in the correct range denoted in the
Technical Data.
4. Then test the driving depth in a sample piece of wood before using. If the fasteners are being driven too
far or not far enough, adjust the regulator to provide less air pressure or more air pressure.
5. Never operate tool unless safety nose is contact with work piece. Do not operate tool without fasteners or
damage to tool may result.
6. Never fire fasteners into air because fasteners may injury operator or others and damage to tool may
result.
Maintenance
WARNING
:
Disconnect the tool from the air compressor before adjusting, clearing jams,
servicing, relocating and during non operation.
·
Regular lubrication, if your tool without using the in-liner automatic oilier, place 2 or 6 drops of
pneumatic tool oil into the air inlet before each work day or after 2 hours of continuous use depending on the
characteristic of work piece or type of fasteners.
·
Check and change all worn or damaged o-rings, seals, etc. Tight all the screws and caps in case personal
injury.
·
Inspect trigger and safety mechanism to assure safe system is complete and functional: no
loose and missing parts, no building or sticking parts.
·
Keep magazine and nose of tool clean and free of any dirt lint or abrasive particles.
10
