Troubleshooting
The following form lists the common operating system with problem and solutions. Please read the form
carefully and follow it.
)
WARNING
:
If any of the following symptoms appears during your operating, stop using the tool
immediately, or serious personal injury could result. Only a qualified persons or an authorized service center
can perform repairs or replacement of tool.
Disconnect tool from air supply before attempting repair or adjustment. When replacing O-rings or
Cylinder, lubricate with air tool oil before assembly.
SYMPTOM PROBLEM
SOLUTIONS
Air leak near top of tool or
in trigger area
1.O-ring in trigger valve are damage.
2.Trigger valve head are damage.
3.Trigger valve stem ,seal or O-ring are
damaged.
1.Check and replace O-ring.
2.Check and replace.
3.Check and replace trigger valve stem,
seal or O-ring
Air leak near bottom of tool.
1. Loose screws.
2. Worn or damaged O-rings or bumper.
1.Tighten screws.
2.Check and replace O-rings or bumper.
Air leak between body and
cylinder cap.
1. Loose screws.
2. Worn or damaged O-rings or seals.
1.Tighten screw.
2.Check and replace O-rings or bumper.
Blade driving fastener too
deep.
1. Worn bumper.
2. Air pressure is too high.
1.Replace bumper.
2.Adjust the air pressure.
Tool does not operate well:
can not drive fastener or
operate sluggishly.
1. Inadequate air supply.
2. Inadequate lubrication.
3. Worn or damaged O-rings or seals.
4.Exhaust port in cylinder head is
blocked.
1.Verify adequate air supply.
2.Place 2 or 6 drops of oil into air inlet.
3.Check and replace O-rings or seal.
4.Replace damaged internal parts.
Tool skips fasteners.
1.Worn bumper or damaged spring.
2.Dirt in front plate.
3.Dirt or damage prevents fasteners from
moving freely in magazine.
4.Worn or dry O-ring on piston or lack of
lubrication.
5.Cylinder cover seal leaking.
1.Repalce bumper or pusher spring.
2.Clean drive channel on front plate.
3.Magazine needs to be cleaned.
4.O-ring need to be replaced.
And lubricate.
5.Replace Sealing washer.
Tool jams.
1.Incorrect or damaged fasteners.
2.Damaged or worn driver guide.
3.Magazine or nose screw loose.
4.Magazine is dirty.
1.Change and use correct fastener.
2.Check and replace the driver.
3.Tighten the magazine.
4.Clean the magazine.
11
