DOCUMENT NO. 920012 REV 2 EFFECTIVE 03-14-18 INFRASCAN CONFIDENTIAL PAGE 28 OF 35
(a)
(b)
(c)
Figure 4-1: (a) Battery compartment; (b) Door removed and disposable batteries shown; (c) Batteries
removed, showing the rechargeable battery pack connector.
Rechargeable Battery Pack Installation
The battery pack needs to be installed with caution to ascertain that the wires are not
pinched. Follow the steps below and place the battery leads as indicated in the picture.
Figure 4-2: Battery compartment with the rechargeable battery pack installed
1. Remove the battery compartment door with a ¼ inch straight screwdriver.
2. Orient the Infrascanner as shown.
3. Inspect the battery leads and ascertain that there is no bare wire exposed going into
the connector. If there are, discard the battery pack and use disposable batteries,
or contact InfraScan to obtain a new battery pack.
4. Plug in the leads from the battery pack to the connector in the battery compartment
assuring proper polarity.
5. Place the battery pack against the left wall of the compartment with the edge
towards the bottom inserted against the battery springs
