Starting up and testing the PS20/30
This procedure describes how to start up and test the PS20/30 to make sure it is ready
to fold and seal your forms. Always perform this procedure at the start of each form
processing session to ensure the best results.
Before you start up and test the PS20/30, make sure all of the following conditions are
satisfied:
•
The fold plates are adjusted and installed properly for the fold you want.
•
The form guides are set correctly to provide enough, but not too much, clearance at
the sides of the form stack.
•
The lid is closed.
•
Forms are properly loaded.
•
The catch tray is pulled out into position.
4. Operation
PS20/30 Iss. 1.
Page 25