V fold set-up
Refer to Figure 13 on page 21.
1.
Measure the length of the fold required.
2.
Adjust the form stop for the first fold plate to the measurement you determined
previously in step 1 as follows:
·
Loosen the locking knobs at each end of the form stop.
·
Using the knobs as handles, slide the stop along the rods until the stop aligns
with the correct settings on the scales. Make sure the scales on each side of the
fold plate show the same settings otherwise the form will not fold squarely.
·
Tighten the two locking knobs.
3.
If the new form is a different width from the last form used, refer to ‘
Adjusting
the form guides
’ on page 22.
4.
Position the V-fold locating lugs of the 2nd fold plate on the V-fold locating
stubs and the rear lugs on the front fold plate locating stubs as shown in figure
12. Replace the lid.
3. Set-up
Page 20
PS20/30 Iss. 1.
Figure 12:
Second-fold plate positioning
