EonStor U16U Installation and Hardware Reference Manual
5-14
Drive Tray Maintenance
disrupted and subsystem components will overheat and may be permanently
damaged.
5.6.2 HDD
Replacement
If one of the hard drives fails it needs to be replaced. To replace a hard-drive please
follow these steps.
1.
Remove the drive bay
from the EonStor enclosure. To remove the drive bay from the
enclosure, the key-lock must be unlocked. To do this, turn the silver key-lock on the
front of the drive tray until the groove on its face is in a horizontal orientation.
2.
Once the key-lock is unlocked
open the front flap
. To open the front flap, lift up the
clip at the front of the drive tray. This will dislodge the hard drive from the enclosure
and the hard drive can be carefully withdrawn.
3.
Remove the retention screws
on the sides of the drive tray from the hard drive and
then remove the hard-drive from the drive tray.
4.
Install the new hard drive. Please refer to the complete hard drive installation
procedure in Chapter 2.
