EonStor U16U Installation and Hardware Reference Manual
2-18
Hard Drive and Drive Tray Installation
Step 1.
Make sure
the key-lock is in the unlocked position
. The key-lock is unlocked
if the groove (on its face) is in a horizontal orientation. If the groove is in a
vertical position, as shown in
Figure 2- 4
then the key-lock is locked and the
front flap on the drive tray cannot be opened.
Figure 2- 4:
Front view of an individual drive tray.
Step 2.
Open the front flap on the drive tray
(see
Figure 2- 5
) To open the flap, push
the clip (shown in
Figure 2- 4
) on the front of the drive tray in an upward
direction. The clip is easily accessible and is easily lifted.
Figure 2- 5:
Drive Tray Front Flap
Step 3.
Line the drive tray up with the slot
in which you wish to insert it. Make sure
that it is resting on the rails inside the enclosure. Once the drive tray is lined
up with the slot, gently slide it in. This should be done smoothly and gently.
Step 4.
Close the front flap on the drive tray
. Make sure the front flap is closed
properly. Closing the front flap ensures that the SCA connector at the back of
the drive tray is firmly connected to the corresponding connector on the mid-
plane board. If the front flap is not closed properly then the connection
between the HDD and the subsystem will not be secure.
Step 5.
To lock the flap into place turn the key-lock until the groove on its face is in a
vertical orientation. (See
Figure 2- 6
)
Key Lock in locked position
Clip
