Infomir MAG-00, User Manual

Page: 16 / 50

MAG-200. User Guide (Rev 1.2 05/02/2010,17:23)
3) Enter the bootstrap loader menu: when the device is turned off press and keep for
several seconds the remote control button «menu» until the menu blue screen
appears.
4) Using
« »
button go to the item «Boot Mode» and with the button
« »
set its value
to
«
DHCP
»
5) Move to the menu item «Exit & Save»
6) Press the button
« ».
The message «Please confirm save change. Press OK» will
appear on the screen
7) Confirm saving the changes with the button «OK»
As the result the screen shows the message «Saving…» and then «OK. Reboot…».
The «tftp load» message appears at the bottom of the screen immediately after reloading in
DHCP loading mode.
Indication the stages of basic software loading
After the device is switched on the logo (if set) appears on the screen and the indicator on
the front panel shows «200». Then the bootstrap loader indicates stages of loading process
simultaneously on the TV screen and on the front panel indicator.
Basic software loading stages Front panel Messages on the TV set screen
The Ethernet cable is not connected «Erln» «No link detected!!!»
Sending dhcp-request «dHCP» «DHCP»
Sending repeated dhcp-request with the
number of attempt # «dHCP» «DHCP Retry#»
Dhcp-request is unsuccessful «Er10» «DHCP Error»
Loading the core from mtd4 partition «nand» «Load from nand»
Error of core loading from mtd4 partition «Er20» «Error loading image from nand»
Content of mtd4 partition is not valid «Er20» «Active partition not valid»
Loading the core/bootstrap from multicast group «load» «Multicast load»
Loading the core/bootstrap according to tftp
protocol «tftp» «Tftp load»
Checking digital signature «chec» «Checking image»
Wrong image format «Er30» «Wrong image»
Wring digital signature «Er30» «Wrong digital signature»
Starting the core/bootstrap «GO» «Loading ...»
16