InFocus MaxFlight MT3000B ELECTRIC, Owner'S Manual

Page: 29 / 121

1-2M Encoders
All encoders (three) are the same. A 400 line, metal disc type. Power to them is from the computer, a 5
VDC signal powers the light diode that shines through the disc to a receiver diode.
1-2N Interface
Interface Control Boards are by Omnitech and located behind left front cabinetry.
1-2O Roll Slip Rings
Located between the weldment and the cockpit. Mounted over the roll shaft it passes the signal to the
cockpit. These units are sealed and no maintenance allowed.
1-2P Steering Wheels/Throttle/Brake and HAAP Box (CIB1000) or( USB
UGCI) Interface
There are two steering wheels and two sets of Gas/Brake pedal units mounted on the
floor boards. These units interface to the HAAP (USB UGCI) controller installed beneath the
seat area. The HAAP box is powered by a DC eliminator transformer that is plugged into the AC
power strip. The USB interface is powered by the computer directly. The signals are transferred
to the CPU via a DH9 connector by way of the roll and pitch signal slip rings to the CPU Com#2
input to the mother board (Older Style Units). On later style units the signal is routed directly to
the computer along the USB bus cable. The controllers are calibrated within the window program
and Monster Truck program configuration windows. See setup instructions in Technical Section
starting at paragraph 5-20.
1-3 Mechanical
1. A-frame - two each, right and left.
2. Center
weldment.
3. Pitch arms two
4. Tail
shaft
5. H frame assembly, attached to the tail shaft
6. Counterweight gear and gear box
7. Counterweight @300 pounds
8. Chair
assembly
9. Seat back assembly
10. Lift drive network
11. Roll motor mounting
12. Pitch motor mounting
13. Roll hub assembly
14. Fiberglass cockpit shells
15. Front stand
16. Rear stand
17. Entry stair assembly
18. Cabinetry
1-4 COMPUTER SYSTEM
Computer System/Control Console
1. CPU- audio card, video card, mother board, Voodoo 3dfx card, motion control board,
network card, modem board, power supply, hard disk drives, CD drive, and software to
control it all.
2. Monitor
3.
UPS (Uninterrupted Power Supply)
4. Power audio amp
5. Audio pre-amp
6. Cabling