Inflight Fitness VANGUARD, Assembly Manual

Page: 15 / 17

26 27
VANGUARD ASSEMBLY INSTRUCTIONS
PLACARD AND ACCESSORY ASSEMBLY
M1. Attach the L/H and R/H Lat Bar Holders using 2 – 3/8” x 3” Bolts, 4 – 3/8” Washers
and 2 – 3/8” Nuts.
M2. Attach the Lat Bar to the chain link pre-installed on the cable end using the pre-
installed quick link on the lat bar.
M3. Attach the Bar Rest to the top of the Low Row Connector using 2 – 1/4” x ½” Flat
Head Screws.
M4. Connect the Rotating Bar and chain using the quick link pre-installed on the chain.
M5. Remove the backing from the adhesive tape on the Leg Extension/ Leg Curl
placard. Place the placard approximately 9 ½” down from the top of the shrouds (1”
below the ¼” screws ) and centered on the Vertical Tubes or on the shrouds if
shrouds are installed.
M6. Remove the backing from the adhesive tape on the Low Row/Bicep Curl placard.
Place the placard just below the Leg Extension/Leg Curl placard.
M7. If no shrouds are being installed attach the placard holder using the pre- installed ¼”
screws and washers behind the press arm station (below the pillow block bearings
and frame pulley).
Remove the backing from the adhesive tape on the Multi-Press/Lat Pull placard.
Place the placard behind the press arm/lat station approximately 8 ¼” down from the
top of the shroud and 1/2 ” from the left edge of the shroud (or even with the top and
left edge of the placard holder).
NOTE: Remember to remove the protective plastic from the placards.
26
Leg Extension/Curl Placard
Bicep/Low Row Placard
Multi Press/Lat Placard
1 - LH Lat Bar Holder
1 - RH Lat Bar Holder
2 - 3/8" x 3" Bolts
4 - Washers
2 - Nuts
Rotating Bar
with Chain
USE PLACARD HOLDER HERE WHEN
NO SHROUDS ARE INSTALLED
27
M1
M7*
Lat Bar
M2
1 - Bar Rest
2 - 1/4" x 1/2"
Flat Head Screws
M3
M5
M6
M7
M4
VIEW WITHOUT SHROUDS