CT-MSEC ASSEMBLY INSTRUCTIONS
CABLE ADJUSTMENT
F1.
Adjust cable tension per the following:
1. Raise the exercise arm to the highest leg curl position.
2. Make sure bolt was installed in second weight plate (STEP D5).*
3. Use the cam washer first to remove slack from the cable.
4. Use the threaded fitting on the top weight if needed to remove more slack.
5. Cable adjustment should be tight enough to raise the pulley arm to the stop
without raising the top weight.
6. Check that the weight pin engages in each weight plate.
Note:
If installing shrouds skip Step F2 and proceed to step G1.
F2.
Remove backing from foam tape on Instruction Placard. Attach Instruction Placards
to Loop Upright aligning outside edge of placard to top and outside edge of Loop
Upright. Remove the protective clear cover.
14
14
