When connected, find the special app,
Cam802 , and open it to observe the
real-time images in the thermal imager.
Analog video: is a switch for transmitting
the videos on a thermal imager and must
be switched on for head-mounted,
wireless, or wired video transmission.
Connection steps for wired transmission
(common display as an example):
①Switch on the analog video;
②Plug the special cable into the thermal
imager as described in chapter 5.3;
③Plug the BNC connector of the cable
into the video input port of the display;
④Adjust the display mode of the display
so that images can be shown on the
display properly;
The system can carry out automatic
detection. When the battery is running
low, the image transmission will not be
enabled, and a prompt will appear on the
display; when the temperature is
relatively low, the operating voltage will
go down, and the time of image
transmission will be shortened due to
battery performance.
Figure 8 shows the image transmission
interface:
Figure 8 Image Transmission Adjustment
6.3.4 Image Transmission
Image transmission is to transmit the
videos on a thermal imager to other
devices, through a wired or wireless
approach, for simultaneous observation,
coordinated command, and quick directions.
It can be performed through head-mounted
transmission, wireless transmission, or
analog videos (disabled by default; must
be enabled to use after the device is
being powered on);
Head-mounted transmission: transmits
images to head-mounted devices. This
option currently supports Jerry-F products
and can transmit videos on a thermal
imager to a Jerry-F product in real time.
For steps to connect to a Jerry-F product,
see the user manual for Jerry-F. (Before
connecting to a Jerry-F product, turn on
its pairing switch. When the head-mount-
ed transmission is switched on, the
thermal imager pairs with the Jerry-F
product. The process lasts 30 seconds.
After that, operate by following the
instructions on the thermal imager.)
Wireless transmission: transmits information
on a thermal imager screen to cellphones,
tablets, computers, or other devices with
a Wi-Fi module (installation of the special
app required) to facilitate observation
and monitoring.
Connection steps for wireless transmission
(cellphone as an example):
①Switch on the wireless transmission;
②Switch on the analog video;
③Turn on Wi-Fi on the cellphone. Search
and connect to the Wi-Fi network with a
name containing "WIFIV_" (the default
password is "12345678" and you cannot
change it);
7
Tyke-L3
Operation and Maintenance Manual
