InfiRay BOLT DIGITAL Series, User Manual

Page: 6 / 25

8 9
8. QUICK START GUIDE
Step 1: Preparing to Use the BOLT TD50L Series
1. Compare the box contents to the accessories list and examine
each for any shipping damage. See Accessories on page 4.
2. Check the lens to ensure there are no smudges or dirt present.
Clean with the included lens cloth, if necessary.
3. Install the eyeguard (1) .
4. Charge the built-in battery pack before using the BOLT TD50L
for the first time. See Charging the Built-in Battery Pack on
page 10.
5. Mount the BOLT TD50L to the weapon using the included 30mm
rings. See Mounting the BOLT TD50L on page 15.
Step 2: Turn On the BOLT TD50L and Adjust the
Focus
1. Open the objective lens cap (15) . If the sunlight is too bright, you
may leave the lens cap closed to prevent the image from being
overexposed.
2. Long press the Power Button for 2 seconds to power on the
BOLT TD50L. The InfiRay logo will appear.
3. Rotate the diopter adjustment ring (2) of the eyepiece until the
interface icons are clearly visible.
4. Rotate the objective lens focus ring (14) to focus on the object
being observed.
WARNING: Do not point the objective lens toward intense
energy sources, such as the sun. This may render the electronic
components inoperative. The warranty does not cover damage
caused by improper operation.
Step 3: Activate and Customize the Reticle
From the home screen:
1. Press and hold the Brightness and Palette Buttons at the
same time for 15 seconds to activate the reticle.
2. Short press the Control Turret to enter the quick menu (see
Using the Quick Menu on page 21):
a. Select the reticle color, white, black, red, or green. The
default is white.
b. Select the reticle type, from 1–6. The default type is 1.
Step 4: Adjust the Image Settings
From the home screen:
1. Short press the Palette Button to set the imaging mode, day,
moon, and star. Day is the default.
2. Short press the Brightness Button to adjust the screen
brightness, from level 1–5. The selected screen brightness
appears in the status bar. The default is 3.
3. Rotate the Control Turret to zoom in and out on the observed
object. See Digital Zoom on page 29.
4. Long press the Palette Button to turn on the PIP window, if
desired. See Picture in Picture (PIP) on page 29.
Step 5: Adjust Rifle Scope Settings
1. From the home screen, long press the Control Turret to enter
the main menu to:
a. Set the date and time. See Settings Menu > Date on
page 38 and Settings Menu > Time on page 39.
b. Set the units of measurement, meters or yards. The default is
yards. See Settings Menu > Units of Measure on page 40.
Step 6: Zero the BOLT TD50L
1. From the home screen, long press the Control Turret to enter
the main menu to:
a. Select the zeroing profile, A, B, or C. See Main Menu >
Zeroing Profile on page 32.
b. Select, or customize, a preset zero distance that matches
the target distance. See Zeroing Menu on page 33.
c. Zero the reticle. See Zeroing Menu > Reticle Zeroing on
page 34.