36
37
e. Changing your zero distance will change the distance
of your X/Y adjustments automatically. If your selected
zero distance has a correction of 1.60” at 100 yards, it
will automatically change to 3.20” if you change the zero
distance to 200 yards.
f. After moving the reticle, a small white dot appears,
indicating the original position of the reticle.
5. Long press
Control Turret
to save the reticle position and return
to the home screen;
OR
a. A 5-second countdown appears on the screen, followed by
a “Saved Successfully” message.
6. Short press the
Power
Button
to exit the interface without
saving the new reticle position.
ZEROING MENU > ZERO DISTANCE SUBMENU >
CUSTOMIZE ZERO DISTANCE
Customize a preset
zero distance
The BOLT TD50L
Series supports
custom zero distances
of 1 to 999 yards or
1 to 999 meters.
1. In the submenu
for the selected
zero distance,
rotate the
Control
Turret
to select the
customization
menu item (the selected zero distance will
appear instead of “000m”).
2. Short press the
Control Turret
to customize the selected preset
zero distance. The selected distance is back-highlighted blue
and white arrows appear above and below the selected digit to
mark the cursor location. The far-left digit is selected by default.
3. Rotate the
Control Turret
to increase or decrease the value of
the selected digit, from 0–9.
4. Short press the
Control Turret
to switch between the three digits.
The two triangle icons will indicate the selected digit.
5. Long press the
Control Turret
to save the custom zero distance
and return to the Zero Distance submenu.
6. The new zero distance appears in the status bar.
Standby
Set automatic standby
status and time
The BOLT TD50L may
be set to automatically
enter standby mode after
a specified time with no
operation.
1. Long press the
Control Turret
to
enter the main menu.
2. Rotate the
Control
Turret
to move
through the menu to
select the standby
menu item.
3. Short press the
Control Turret
to
enter the standby
submenu.
4. Rotate the
Control
Turret
to move
through the standby options, 10min, 20min, 30min, and off.
5. Short press the
Control Turret
to confirm the selection and return
to the main menu.
6. The standby icon and status (10min, 20min, 30min, or off)
appear in the status bar.
7. Once set, the BOLT TD50L will automatically enter standby
mode, after the set number of minutes of inactivity, to conserve
battery life.
8. When in standby mode, short press the
Power
Button
to exit
and return to the home screen.
NOTES:
• When
10min
,
20min
, or
30min
is selected:
• The BOLT TD50L will enter standby mode automatically
when the BOLT TD50L is tilted up or down at an angle of
more than 70° or left or right at an angle of more than 30°.
• The BOLT TD50L will not enter standby mode while it is in a
level position.
• When
off
is selected, standby mode is turned off and the rifle
scope will operate until the batteries run out.
• Standby mode may be manually activated from the home screen
at any time:
• Short press the
Power
Button
to enter / exit standby and
return to the home screen.
