5
Pedestal Bracket Dimensions
Figure 3-8
3.2.2 Installation Procedures for Over-roof Mounting
Note:
When installing the dome (bracket mount), as to the usage of
dustproof sponge and waterproof tape, please refer to
Appendix III
and
Appendix IV
separately.
Easily install your IP dome in below steps:
1.
Place and secure the bracket base at a suitable position against
the wall. For over-roof horizontal surface installation, the base,
upright bracket, pedestal bracket and fastening bracket should be
secured with the sustaining pipe together. For over-roof sidewall
installation, only the pedestal bracket and fastening bracket
should be secured with the sustaining pipe. Refer to sector 3.2.1
for the brackets’ detailed information.
Sidewall Mounting
Horizontal surface Mounting
Figure 3-9 Install Bracket Base
2.
Take out the upper housing from the dome package. Pull the
system cables (power cable, network cable and etc.) through the
bracket and lead them out from the bottom of bracket.
3.
Screw the upper housing onto the mount bracket. For outdoor
housing, it is recommended to apply thread compound to the
threads on the housing. Secure the connection with a holding
screw.
Sidewall Mounting Horizontal Surface Mounting
Figure 3-10 Installing Housing
4.
Take out the dome drive from the dome package. (Note:
dimisters are included in outdoor dome drive). The address ID
and baud rate can be set via either software or DIP switch. If
setup via DIP switch is selected, please refer to Appendix I.
5.
Line up the two tabs located on the upper side of the dome drive
with the corresponding grooves in the housing. Insert both tabs
into the grooves. Push up the dome insert until both tabs click
into place. Be sure that you hear two clicks.
6.
Take out the dome bubble from the dome package and fix the
safety cord. As one end of safety cord has already fixed to the
upper housing, and the other end should be tied to the dome
bubble. Line up the screw holes of the dome bubble with
corresponding holes on the housing, and then secure the cover
with supplied screws.
Figure 3-11 Installing Dome Bubble
7.
Turn on the power. The dome will pan, tilt, and zoom to initiate
system parameters as well as to verify the normal operation of
the dome drive.
After the initiation sequence, the dome will stop and be ready for
programming and operation.
