10
A View
4-Ø6.5
Ø85
Ø100
A
Ø218
R77.8
Ø154
81
81
Ø57
27
5
235
140
Through hole
evenly distributing
Figure 3-30
3.6.2 Outdoor Mounting Specifications
27
5
Ø240
R77.8
81
255
150
16
2
Ø218
50
Ø57
A View
3-Ø6.5
Ø85
Ø100
A
Through hole
evenly distributing
A view
27
5
Ø240
R77.8
81
255
150
16
2
Ø218
50
Ø57
9
0
°
4-Ø6.5
Through hole
evenly distributing
90°xØ9bottom
Ø66
Ø85
Ø100
A
Figure 3-31
3.6.3 Installation Procedures for Pendant Mounting
Note:
When installing the dome (bracket mount), as to the usage of
dustproof sponge and waterproof tape, please refer to
Appendix III
and
Appendix IV
separately.
Easily install your IP dome in below steps:
1.
Place the pendant mount base at a suitable position against firm
ceiling, and secure it with expansion bolts.
For dimensional diagram of the pendant mount base, please refer to
the following figure.
85
4
Through hole
Evenly distributing
6.5
Bottom
90°
9
×
Indoor mounting
120°
3- 6.5 Through hole
100
85
Evenly distributing
Outdoor mounting
Figure 3-32 Installing Mount Base
2.
Screw the suspender into the pendant mount base, and then the
housing holder into the suspender. Secure the connections with
holding screws.
Indoor Outdoor
Figure 3-33 Installing Suspender and Housing Holder
3.
Take out the upper housing from the dome package. Pull the
system cables (power cable, network cable and etc.) through the
bracket and lead them out from the base plate of bracket.
4.
Screw the upper housing onto the housing holder. Secure the
connection with two holding screws. It is recommended to apply
thread compound to the threads on the housing. Secure the
connection with a holding screw.
