Infinity 800 HD UBL, Instruction For User, Installation & Servicing

Page: 12 / 60

P a g e | 10
LT 7941 Issue No 3 (04/22)
800 HD with UBL USERS INSTRUCTIONS
Cleaning the 800 HD with UBL Appliance
Ensure the appliance is cold before proceeding.
The outer metal work frame should be cleaned using a damp cloth.
To clean the glass panel , remove the four M4 nuts fixing the glass clamp to the glass panel. (See
Fig 8). With the nuts removed, pull the glass clamp clear of the four studs. Finally lift the glass
panel out of the bottom glass fixing.
Using a damp cloth and warm soapy water will remove a majority of stains. For more substantial
marking we recommend the use of ceramic hob cleaner. These are available from all leading
super markets. The brands
of hob cleaner we have tested and found suitable are “Hob brite” &
“Vitro clean”. Ensure the glass is dry and re-assemble. Take care not to over-tighten the glass as
this will result in the glass breaking. The glass is not covered by warranty.
Note- Never operate the appliance when the glass panel is removed or broken. The glass may discolour quickly
when first installed, and it should be cleaned. This is due to the burning of the refractory fuel bed shapes.
To Clean the Pilot assembly . Remove the four M4 nuts and glass clamp (See Fig 8). Carefully lift
the glass panel from within the bottom location. Remove the log and bark chip shapes. Lift out
the air tray assembly from within the burner shelf.
The pilot is located on the right hand side of the appliance, remove any debris in or around the
pilot head and the aeration hole. This can be achieved using the nozzle of a vacuum cleaner. It
is advisable not to blow the debris within the pilot head or aeration hole as this may cause more
of a restriction and not rectify the problem.
Note-Take care when cleaning in this area so as not to damage the pilot assembly.
4 off glass fixing nuts