Infinity 480 FL, Owner'S Manual

Page: 9 / 32

9 LT 6117 (12/13 Iss 11)
480 FL Users Instructions
SECTIONTHREE Cleaning Continued
REMOVING GLASS PANEL

Remove the two side covers LH and RH which are held
on with magnets.

Undo the two M4 nuts retaining the glass fixing bracket
using the tool provided then pull clear from location studs.

Carefully lift the glass panel from within the bottom
location slot.
SECTION FOUR Fuel Bed Cleaning and Layout

Before you clean any part of the appliance ensures that the appliance is turned off and cold.

Use only the fuel bed components provided and no additional parts must added.

Incorrect positioning of the fuel bed components could result in the staining of the glass panel.
Important: -
Refer to the ‘Health & Safety Notice located on page 3 of this booklet
before
cleaning or replacing any refractory material.

The fuel bed components are delicate and they should be handled with great care.

The moulded shapes may be removed for cleaning. They can be brushed very gently with a soft
brush to remove dust or any deposits.

A vacuum cleaner may only be used after the loose components and moulded shapes have been
removed.
CARE SHOULD BE TAKEN TO AVOID CONTACT WITH THE REFRACTORY LINING THIS IS A
DELICATE SURFACE AND SHOULD
NOT BE WIPED OR RUBBED.
It is important that all the fuel bed moulded shapes are positioned as shown in these
instructions.
Fitting the fire liners
Once the firebox is secured into position fit either the vermiculite or brick back liners supplied.
Position the 2- piece rear liner behind the 3 lugs located at the bottom rear of the firebox. The
vermiculite liner has a vertical joint and the brick back has a horizontal joint. Ensure these are aligned
centrally.
Rest the side liner on the location bracket on either left or right hand side of fire box. Push up and into
position. The vermiculite liners are reversible but the brick back liners will only fit one way.
Once liners are in place fit the air-tray and lay fuel bed.