Infinity 480 FL, Owner'S Manual

Page: 18 / 32

18 LT 6117 (12/13 Iss 11)
480 FL
Installation Instructions
SECTION EIGHT Siting the Appliance Continued
CHECKING THE FLUE AND FIRE OPENING

Check that the chimney conforms to the required specifications as previously stated. Examine the
condition and carry out any remedial work including removing any debris from the base.

If the flue has been used for solid fuel it should be swept prior to the installation

Prior to installing the appliance a smoke test (using a smoke bomb) should be carried out to check
that satisfactory smoke clearance has been established.
If all the smoke is not drawn into the flue, pre-heat the flue with a blowtorch or similar and re-
check. If there is any uncertainty examine for the cause and, if necessary, seek expert advice.
No combustible material should be fitted inside the fireplace opening.

When installing this appliance against a dry lined (plasterboard) wall ensure that any void
between the plasterboard and the wall is sealed with a suitable non-combustible material (i.e.
plaster or mortar).
480 FL
Installation Instructions
SECTION NINE To Install the Appliance
GAS SUPPLY ROUTING
Use rigid or semi
– rigid tube to connect the supply. Determine
the gas supply pipe route to the appliance before installing the
fire.
Fixing Firebox Assembly

Slide the firebox into the fireplace open guiding the gas
supply pipe through the hole at the rear LH bottom of the
firebox.

Retain the Firebox using wall plugs and screw using the four
holes within the firebox flange.

Refit the grommet over the pipe and seal around the inlet
hole.

The Fireplace frame can now be located onto the firebox
assembly and retained using the six off M4 nuts provided.

Remove the gas connection cover located within the burner
shelf left hand side and connect to the restrictor elbow
provided.
Note: - The isolation valve must be fitted at a angle to allow
access to the restrictor plug plus gas pressure test nipple.

At this point the fireplace or false chimney breast front will
need to be constructed.

Connect battery pack as described in section 2. (Operating
the appliance). Locate the battery pack in the holder
positioned within the fireplace frame.

Now check that a signal is being received by pointing the
remote control hand set in the direction of the appliance and
press ON / OFF Key for at least 2 seconds. On release a
bleep should be heard and the ignition process will start.