Inficon XTC/3, Operating Manual, Page: 72 / 210

3 - 33
XTC/3 Operating Manual
6
Average Power = xx.x %
7
S Value = 0 to 9999
8
Q Value = 0 to 99
9
Begin Frequency = xxxxxxxx.x Hz
10
End Frequency = xxxxxxxx.x Hz
11
Xtal Life = xx % (0 - 99)
12
Normal Completion or
13
End On Time Power or
14
End In Stop from (Stop Reason). Stop Reasons are one of the following:
 Keyboard

Xtal Fail
 Max Power
 Hand Controller
 Communications

Digital Input
 Power Loss
 Rate Dev Fail
 Crystal Switch Fail
NOTE: If the layer is the first one of a process, a preface Begin Process xxx
(xxx is the process number or name (XTC/3M only), if the name is
programmed.) is output. If the layer is the last one of the process, a
postscript
End Process is output. The data log information is available via
the remote communications S19 command. See Remote Communication
status commands,
section 5.2.2.5 on page 5-28 or section 5.3.5.5 on page
5-42 .
3.6.15 TCP/IP
The optional TCP/IP interface will provide all the commands available through the
standard RS232 interface. The interface uses a static address entered via XTC/3
front panel (see
section 4.4.3.1 on page 4-25 ).
DHCP is not supported.