5 - 19
XTC/3 Operating Manual
Command ID = 3 "Specific Layer"
<Parameter> = <2 Bytes>Desired Layer
Response:
<Byte> 1-32, film number of given layer
5.2.2.4 Standard UPDATE Commands
5.2.2.4.1 Update Block
Command:
UB< Command ID> <List of parameters>
Response:
None (Just header and trailer)
List of parameters for Command ID 1 =
<Number of Bytes in Response><General Parameters><Film 1
Parameters>…<Film32 Parameters><Inputs><Outputs><Film 1
Name>…<Film 32 Name> <Process 1>…<Process 99><Process 1
Name>…<Process 99 Name>
Number of Bytes in Response (2 bytes)
All General parameters (4 bytes per parameter)
All parameters for each film (4 bytes per parameter) (9 or 32 films based on
XTC/3S or XTC/3M)
All input definitions (9) (1 byte per input) (XTC/3M only)
All output definitions (20) (1 byte per output) (XTC/3M only)
All output types (20) (1 byte per output) (XTC/3M only)
All Film Names (null terminated) (32 films based on XTC/3M only)
Every process layer list for each process (99) (2 byte length (for the number of
layers programmed) followed by 1 byte for each programmed layer)
(XTC/3M only)
All process Names (null terminated) (99) (XTC/3M only)
Note: maximum allowed bytes are 57,800. If there are more bytes in the
command then the data should be broken into the following commands.
List of parameters for Command ID 2 =
<Number of Bytes in Response><General Parameters><Film 1
Parameters>…<Film32 Parameters><Inputs><Outputs><Film 1
Name>…<Film 32 Name
Number of Bytes in Response (2 bytes)