Inficon Southern Cross IRwin, Quick Start Manual

Page: 24 / 25

No. Message Possible error sources Remedy
E5 Battery level too low
(count down to power
off) Battery low Switch off detector and charge battery
E7 SnO
2
voltage error System error Restart detector.
If problems remains: Contact INFICON service.
E8 Detector shuts down System error Restart detector.
If problems remains: Contact INFICON service.
E9 Red LED and constant
beep HW watchdog trigged Perform hardware reset.
Restart detector.
If problems remains: Contact INFICON service.
E10 O
2
Sensor bias lost O2 sensor bias lost due
to uncontrolled shut
down. Check in Ex Tox mode that O
2
value is OK (close
to 20.9%). If not, leave the detector on until O2
sensor shows 20 - 22% in air. This can take up to
12 hours.
E11 “IR Lamp" has red
cross in function test
result screen. IR system error Restart detector.
If problems remains: Contact INFICON service.
E12 “Pump & Valve" test
has red cross in
function test result
screen. Exhaust blocked Restart detector.
If problems remains: Contact INFICON service.
Pump dirty or broken Contact INFICON service.
E13 “Pump & Valve" test
has red cross in
function test result
screen. Valve clogged Restart detector.
If problems remains: Contact INFICON service.
System error Restart detector.
If problems remains: Contact INFICON service.
E14 “Pump & Valve" test
has red cross in
function test result
screen. Exhaust blocked Check that nothing is blocking the exhaust.
If alarm remains: Contact INFICON service.
Reference inlet blocked Check that nothing is blocking the reference inlet.
If alarm remains: Contact INFICON service.
Pump dirty or broken Contact INFICON service.
E15 "Gas Sensors" has red
cross in function test
result screen. Sensor error or warm-up
drift Restart detector.
If problems remains: Contact INFICON service.
E16 "Gas Sensors" has red
cross in function test
result screen. Sensor error or warm-up
drift Restart detector.
If problems remains: Contact INFICON service.
2 5