5.3.1 Install software for data transfer
Install the IRwin App software on your computer.
More complete information about supporting software can be found in separate documents.
5.3.2 Pairing the leak detector with computer via Bluetooth interface
Set IRwin in one of the following operating modes: Bar Hole, Gas Purity, House, Above Ground and
Confined Space. Bluetooth is active in all these modes.
Make sure IRwin App is installed on your computer.
Make sure Bluetooth is activated on your computer.
Establish a Bluetooth connection. Refer to the instructions on your computer.
When searching for your detector on the computer, locate the correct serial number of your detector
and select that device on the computer. Some computers will prompt you to acknowledge that a
connection "password" has been correctly transferred to the detector. You must confirm this on both
computer and detector.
Start the program IRwin App on your computer.
In the IRwin App on your computer, Click Connection (menu item) > Port and select your detector.
Data Transfer/Bluetooth
The serial number of the leak detector is displayed in the drop down menu.
Select "Connect" on the menu bar in IRwin App.
Click "Start Streaming" on the menu bar of IRwin App.
1
6
1
2
Follow the instructions on the screen.
1
2
3
4
5
5.3.3 Transfer log files from leak detector to computer
You have installed IRwin App software on your computer.
You have recorded at least one log fil in your detector.
You have activated the Bluetooth interface on your computer.
Switch on the leak detector
Perform self-test.
Make sure IRwin is not in Ex or ExTox mode. Bluetooth is active in all other
modes.
1
2
3
