10
Forgetting to put your Batteries in Sleep Mode
If the sleep process has not been followed correctly
there may be a loss of autonomy in future
uses of the battery. To remedy this situation, leave the battery on charge for between 12 and 72
hours (for extreme cases of incorrect storage that cause an imbalance).
Full autonomy can also be recovered over several daily charges that can be spread over the fi rst week of
work. To do this, make sure the battery remains on the charger every night during the fi rst week of work.
Reminder: Putting the battery to sleep mode eliminates any risk of battery imbalance (see page 11).
Battery storage instructions
Store the battery and the charger in a well ventilated area, free from infl ammable products or heat
sources, and keep out of reach of children.
Do not store empty batteries. If the battery is very fl at it will no longer charge and will be considered
to be out of service.
Do not store the battery without carrying out the Sleep / Winter mode process.
Do not store batteries that are out of service, return them to your approved INFACO dealer.
Do not store batteries when they are connected to the charger or to a tool.
Do not store the charger connected to the mains power supply.
All failures to follow the storage and safety instructions will result in the manufacturer’s guarantee
being voided.
There is a fi re hazard if the product suffers damage (impacts, being dropped, exposure to
high temperatures, etc.).
According to the 2002/96/EC standard, do not dispose of the battery with household waste,
do not burn it or dispose of it in water. Do not open the battery.
Return the battery to an approved INFACO dealer.
Used or defective batteries must be recycled according to the 91/157/EEC directive.
Charger safety
Temperature fault on channel 1:
Flashing red LED
1. Remove the battery from channel 1 and wait a few
minutes for the battery to cool down.
2. Place the battery on the charger. If the problem persists,
please contact your approved INFACO dealer.
Temperature fault on channel 2:
Flashing red LED
1. Remove the battery from channel 2 and wait a few
minutes for the battery to cool down.
2. Place the battery on the charger. If the problem persists,
please contact your approved INFACO dealer.
Channel 1
Channel 2
NOTMAL1B15_ENUSA_01.indd 10
NOTMAL1B15_ENUSA_01.indd 10
15/07/2020 10:40:53
15/07/2020 10:40:53
