Indmar 350 H.O., Operator'S Manual

Page: 57 / 80

6-12 Indmar Marine Engines
sensor and a dashboard mounted light. If low oil pres-
sure is sensed, this lamp will light indicating the problem.
Shut down the engine and check the transmission fluid
level. Refer to Chapter 6,
Check Transmission Light for
more information.
If transmission service is required, note the Serial
Number of the transmission stamped onto the ID plate
on the top of the transmission housing. It is good practice
to note the serial number noted and keep it with other
owner related information.
Checking/Adding Transmission Fluid
Check fluid only with engine OFF and boat floating level,
or level on trailer. The transmission dipstick is located on
the top of the transmission. Dipsticks may be marked
“ADD” and “FULL” or “H” and “L” (high and low); maintain
fluid level between the two marks.
Check level immediately after turning engine
off. Transmission fluid may be hot. Be careful
not to burn yourself.
1. Remove the dipstick and wipe with a clean towel.
2. Insert the dipstick completely (do not screw in
threaded dipstick to check fluid). Remove the dipstick
and read fluid level.
3. Return dipstick after level check. Make sure it is
secured in place.
4. If level is below “ADD” mark, add the proper fluid until
it reaches the full mark. Add fluid through same tube
as you removed the transmission dipstick.
Figure 6.9 – Walters V-Drive Dipstick Location
INDM-A031
CAUTION
OM0502-04 Body 11/14/03 11:23 AM Page 6-12