Index MS16-6, Operating Instructions Manual

Page: 5 / 82

Preface
General notes
The maintenance activities described in this document essentially pertain only to the
machine. Maintenance activities of auxiliary units (e.g., bar loading magazines,
extraction systems) are described in the documentation of the specific
manufacturer.
The maintenance and servicing activities must absolutely be observed. Failure to
conduct maintenance and servicing in accordance with these instructions
(especially not at the respective intervals) rules out any claims for damages. This
does not apply if it is proved that the non-compliance with the maintenance and
servicing activities is unrelated to the defect. Normal wear and tear, especially of
components such as bearings and seals, is not a defect. These components are
therefore excluded from the warranty. It is recommended to keep a written log of all
maintenance activities carried out.
INDEX multi-spindle lathes generally require cutting oil (based on
mineral oil) as a cooling lubricant. The use of unsuitable water-based
cooling lubricants (so-called emulsions) or of cutting oils that are not
based on mineral oil can cause considerable damage to the
machine. Therefore, such cooling lubricants may be used only with
prior written approval by INDEX . The resulting requirements for
increased maintenance must be followed carefully. Considering the
interactions between cooling lubricant, the material used in each
case, any additives, etc., INDEX 's approval is limited to the basic
safety of using the cooling lubricant on the machine. The testing and
avoidance of interactions are the responsibility of the operator,
INDEX rejects any liability. Be sure to conduct adequate tests prior to
production use.
Maintenance intervals
The maintenance intervals are given based on the operating hours
counter / “Hydraulic system On” operating condition.
Maintenance intervals displayed on the controller (XPanel)
Depending on the respective machine type and the different
controller types, a corresponding message is issued on the controller
when a maintenance interval is reached. The maintenance
instructions stored on the respective controller provide information
(maintenance log) explaining the service and maintenance activities
to be performed.
Preface
1
Maintenance Instructions
MS32-6.2
DIM012EN - 03.06.2020