17
c)
Minimum regulation of the hob burners:
•
turn the tap to minimum;
•
remove the knob and adjust the regulation screw, which
is positioned in or next to the tap pin, until the flame is
small but steady.
N.B.:
in the case of liquid gas, the regulation screw
must be screwed in to the bottom.
•
check that the flame does not turn off when you turn
the tap quickly from high to low.
d)
Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting the gas oven to different types of gas
a)
Replacing the oven burner nozzle:
•
remove the warming drawer;
•
remove the sliding protection “
A
” (see Fig.C);
•
remove the screw and then the oven burner “
V
”(see
Fig. D). Remove the oven door to facilitate this
operation.
•
unscrew the oven burner nozzle using the special
socket spanner for the nozzles (see Fig. E), or better
still a 7 mm socket spanner, and replace it with a nozzle
suited to the new type of gas (see table 1).
Fig. C
Fig. D
Fig.E
b)
Minimum regulation of the oven burner without
thermostat:
•
light the burner as described in the paragraph “the oven
knob” of the instruction booklet;
•
take the knob to minimum, indicated by
+
.
•
remove the knob and turn the regulation screw which is
positioned in or next to the tap pin until the flame is
small but steady.
N.B.:
in the case of liquid gas, the regulation screw
must be screwed in to the bottom;
•
check that the burner does not turn off when you turn
the knob from high to low or when you open and close
the oven door quickly.
Important
On completion of the operation, replace the old rating
sticker with one indicating the new type of gas used. This
sticker is available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary)
from the recommended pressure, it is necessary to fit a
suitable pressure regulator onto the inlet pipe in compliance
with current National Regulations relative to “regulators for
channelled gas”.
WARNING
To remove the sliding protection “
A
”, unscrew screw “
S
”.
When you have finished, replace the protection and lock it
in place with screw “
S
”.
Before using the oven, make sure the sliding protection
“
A
” is fastened in the correct position.
A
V
S
A
