Indemnis Nexus i2 PRS, Operation Manual

Page: 17 / 30

17 17
N E X U S | E Q U I P M E N T O P E R AT I O N S G U I D E - V 1 . 5
PREVENT DAMAGE
|
SECURE ATS CABLE
Securing the ATS Harness Cable when the Nexus is not installed:
1) Take the USB -C cable from the ATS and gently curl the cable about 3 inches from the end of the USB plug.
2) Press the USB-C Cable against the Arm and attach tightly using the Nexus Velcro Strap. Make sure that the cable is on the front side
of the arm and NOT on the top of the arm.
The velcro strap buckle should be inside the cable loop as shown below to prevent the
cable from slipping out.
3) Slide the Strap about 1/2 Inch down from Top Arm Bracket on the Inspire 2.
4) There should be about 5 inches of cable between the strap and the ATS to allow the Arm to raise during flight.
5) Check to make sure that prop is not making any contact with the USB-C. Readjust cable position if there is any contact.
This is an extremely
important step
DO NOT FLY YOUR INSPIRE 2 WITHOUT
THE ATS HARNESS SECURED.