INDA AV054B, Manual

Page: 5 / 32

5
Insert the power supply cable, connect it to the G terminal and tighten the
screws of the cable clamp (fig. 2b).
3 Insert the dowels and fasten the rear part of the wall support to the wall
with the screws provided (fig.3).
4 Apply the wall-support cover and fasten it with screw E . (fig.3).
5 Switch the power on at the mains switch.
The hair dryer is now ready to use.
Use and product care:
Support switch B (Fig.0).
Hairdryer switch C (Fig.0):
ON =On/Off (pressure must be maintained to operate the hairdryer)
Slide Switch D (Fig.0):
Cool = (low power)
1 = (medium power)
2 = (maximum power)
• When not in use, the mains switch on the wall holder B (Fig.0)
should be in the “Off” position.
• The hairdryer requires no special care or attention.
• You can clean your appliance with a cloth dampened with water.
Attention: The cleaning of hairdryers with detergents, solvents, alcohol
and other chemical products is strictly prohibited. When necessary, the air
inlet grill should be cleaned with a soft brush or by vacuum cleaner.
• If the hair-dryer overheats because of incorrect use or it is defective,
it will stop automatically. In this case switch the support switch B (Fig.0) to
position 0, let go of the hair-dryer switch B and remove the external cause
of overheating. After the appliance has cooled down for a few minutes it
will be ready for use again.