INDA AV054B, Manual

Page: 4 / 32

4
irons or fan heaters.
• Do not try to salvage an electrical appliance which has fallen into water.
• Turn the unit off when you put it down.
• When using the hairdryer, always make sure that grid X (fig.0) is not
obstructed. Lack of air suction will overheat the appliance, temporarily di-
sabling it.
• Do not use hair-spray while the appliance is switched on.
Installation:
The wall holder may be installed in one of two ways:
A = for fixed connection lead
B = for mobile connection lead
Attention: before installing the wall holder always switch off
the general switch of your mains electricity.
Each time the appliance is opened, the switch must be used to disconnect
the appliance. The cable to connect to the power supply must be type
H05VV-F 2x1,5 mm
2 .
Method A
1 Unscrew the screw E and remove the cover from the wall unit. (fig.1)
Mark the fastening holes on the wall. Drill the wall with drill Ø 6. (fig.1)
2A Break the plastic membrane F so that the power supply conductor can
pass through. (fig.2a) Connect the supply cable to terminal G (fig.2a)
3 Insert the dowels and fasten the rear part of the wall support to the wall
with the screws provided. (fig.3 )
4 Apply the wall-support cover and fasten it with screw E . (fig.3).
5 Switch the power on at the mains switch. The hair dryer is now ready to
use.
Method B
1 Unscrew the screw E and remove the cover from the wall unit. (fig.1)
Mark the fastening holes on the wall. Drill the wall with drill Ø 6. (fig.1)
2B Break the plastic membrane H . (fig.2b).
Insert the cable gland I supplied (fig.2.b).
Loosen the screws of the cable clamp L (fig. 2b).