INDA A0452A, Manual

Page: 5 / 32

5
3B Break the plastic membrane D . (fig. 3b).
Unscrew the screws of the cable clamp F (fig. 3a).
Insert the power supply cable, connect it to the E terminal and tighten the
screws of the cable clamp F (fig. 3b).
CAUTION: this device has double insulation but does not have an earth.
Insert the dowels and fasten the rear part of the wall support to the wall
with the screws provided (fig.3b).
4 Apply the wall-support cover and fasten it with screw G . (fig.4).
5 Switch the power on at the mains switch. The hair dryer is now ready
to use.
Use and product care:
Support switch A (Fig.0).
Hairdryer switch B (Fig.0):
ON =On/Off (pressure must be maintained to operate the hairdryer)
• When not in use, the mains switch on the wall holder A (Fig.0)
should be in the “Off” position.
• The hairdryer requires no special care or attention.
• You can clean your appliance with a cloth dampened with water.
Attention: The cleaning of hairdryers with detergents, solvents, alcohol
and other chemical products is strictly prohibited. When necessary, the air
inlet grill should be cleaned with a soft brush or by vacuum cleaner.
• If the hair-dryer overheats because of incorrect use or it is defective, it will
stop automatically. In this case switch the support switch A (Fig.0) to po-
sition 0, let go of the hair-dryer switch B and remove the external cause of
overheating. After the appliance has cooled down for a few minutes it will
be ready for use again.