Golden Tee
®
Home Edition
Page 28
© Copyright 2020 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
Control Problems
Symptom
Probable Cause
Solution
Button does not work.
Switches Common post is not
connected to digital ground.
Verify continuity to digital/power
supply ground.
Signal wire is not connected to the
Normally Open post of the switch.
Verify continuity from the I/O Board
to the Normally Open post of the
switch.
Switch is defective.
Replace defective switch.
Button always indicates closed in
the player control test. Pressing it
will show it is not depressed.
Signal wire is connected to the
Normally Closed post of the switch.
Connect signal wire to the Normally
Open post of the switch.
Button always indicates closed in
player control test even with the
switch disconnected entirely.
Defective I/O Board.
Test on a known good system.
Replace if necessary.
Trackball is not functioning in any
direction.
Trackball is not connected to the
I/O Board properly.
Verify the trackball is connected to
J208 labeled trackball on the I/O
Board.
Defective trackball Interconnect
cable.
Verify continuity on the trackball
Interconnect cable.
Trackball is defective.
Replace trackball.
I/O Board is defective
Replace I/O Board. Try it on a
known good system.
Trackball does not work in a
certain direction.
Trackball cable is defective.
Verify continuity on the trackball
cable. Repair or replace if needed.
Trackball is defective.
Repair or replace the trackball. Try it
on a known working system.
I/O Board is defective.
Repair or replace the I/O Board. Try
it on a known working system.
Trackball works intermittently.
Inside of the trackball is dirty.
Clean the inside of the trackball.
Rollers are worn.
Replace the rollers and bearings.
Trackball is over-tightened.
Do not over-tighten the trackball.
Tighten just enough to flatten the
lock washers.
HDTV Video Problems
Symptom
Probable Cause
Solution
There is no picture during boot up.
Incorrect video cable configuration.
Be sure you are using the proper
cable connections. Refer to the
HDTV connections configurations.
Connected to the wrong output on
the system box
Refer to the HDTV connections
configurations.
Connected to the wrong input on
the HDTV
HDTVs usually have more than 1
input for a certain input type.
Examples are Component 1 & 2;
HDMI 1 & 2.
Incorrect input selected on the
HDTV
Be sure the correct input is selected
from the HDTV input menu.
Example: If using HDMI 1 that input
must be selected from the HDTV
video input menu.
DIP switch setting SW 201 on the
I/O Board set incorrectly.
Sw201 on the I/O Board must be
configured to match the method of
video you are using.
Summary of Contents for Golden Tee Home Edition
Page 1: ...Rev 10 2020 ...
