Golden Tee
®
Home Edition
Page 11
© Copyright 2020 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved. PN 815000356RB
Trackball Replacement
To replace a trackball, open the control panel and remove the 4 long screws holding the trackball in place. Be
careful not to lose any of the screws, washers and lock washers. Disconnect the wire harness and ground wire
and remove the old trackball. Position the new trackball in the proper orientation over the existing standoffs.
Make sure that the arrow on the trackball that points to the monitor is pointing up. Replace the 4 long screws and
washers. Do not over tighten! Screw in until the lock washer is fully compressed. Reconnect the wiring
connector and ground wire.
Button Replacement
All of the buttons on the control panel require a 1 1/8
th
inch hole, and are pre-drilled on the dedicated control
panel. To remove a button, disconnect the wires from the button assembly by sliding the wires off of the micro
switch posts. Next carefully twist the micro-switch assembly off of the button posts. Finally, unscrew the nut to
remove the button from the control panel.
Place the new button assembly into the hole and position the smaller side of the micro-switch housing to face the
rubber bumper, angled towards the middle. Tighten the supplied nut using a pushbutton wrench. Do not over
tighten. Install the micro-switch by snapping it onto the pushbutton assembly by hand. Position the assembly so
the micro switch posts face the rubber bumper, angling towards the middle. Reconnect the wires by sliding the
wire assembly onto the contact posts of the appropriate micro switch. See the wiring diagrams in the back of this
manual.
L.E.D. Lighted Buttons
The Help and Options buttons on the Golden Tee Home Edition are Light Emitting Diode buttons.
The housing for the L.E.D. snaps into the back of the button assembly. The L.E.D. must be
installed properly for the light to function properly. The Anode/positive side of the L.E.D. is
connected to the +5 volts, and the Cathode/negative side of the L.E.D. is connected to the
appropriate signal wire. The L.E.D. slides into the housing and the housing is marked Positive and
Negative. See the lamps connector J202 in the cabinet wiring diagram in Appendix D.
Control Panel Removal
To remove the control panel from its hinge, Disconnect the trackball cable, field-ground wire, and
the control panel interconnect connector to the I/O Board. Remove the screw that attaches the
safety cable to the control panel. Remove the four ¼” screws holding the panel to the hinge.
Control Panel Graphics Removal
The control panel artwork has been screened onto a solid sheet of polycarbonate, which is resistant to scratches
and burns. Unfortunately, long exposure to excessive situations may damage the surface over time. To remove
and replace this piece, the pushbutton and trackball assemblies must first be removed. Separate the
polycarbonate piece from the wood portion of the panel by starting at one corner and slowly peeling the two apart.
The overlay has adhesive on the entire surface and will take some force to separate the pieces due to the
adhesive. Once removed, the graphic overlay will not be able to be used again.
Control Panel Graphics Installation
To install a new polycarbonate graphics overlay, make sure the wood control panel surface is clean, smooth, and
free from glue, dirt and debris. Remove the paper protecting the adhesive from the new artwork/cover panel.
Carefully place it on the wood panel, aligning it properly. Press and smooth firmly to assure that it is secure.
Replace the buttons and trackball in the correct orientation.
Note:
The field ground wire is critical to avoid electrical problems and assure optimal performance.
Summary of Contents for Golden Tee Home Edition
Page 1: ...Rev 10 2020 ...