Legal Notice
3
LEGAL NOTICE
Copyright © 2003 Inalp Networks AG
All rights reserved. No part of this publication may be reproduced without prior written permission
from Inalp Networks AG.
Limitation of Use
Inalp Networks AG reserves the right to make changes in specifications and other information
contained in this document without prior notice. The information provided is subject to change
without notice. In no event shall Inalp Networks AG or its employees and associated companies be
liable for any incidental, special, indirect or consequential damages whatsoever, including but not
limited to lost profits, arising out of or related to this manual or the information contained within it,
even if Inalp Networks AG has been advised of, known, or should have known, the possibility of
such damages.
Trademarks
Inalp, the Inalp Logo, and SmartNode are registered trademarks of Inalp Networks AG. SmartWare
and SmartView Management Center are trademarks of Inalp Networks AG. All other trademarks
mentioned in this document are property of their respective owners.
EU Declaration of Conformity
The EU Directives covered by this Declaration
99/5/EC
Guideline of the European Parliament and the Committee for the Harmonization of the
Legal Regulations of the Member States concerning radio equipment and
telecommunications terminal equipment and the mutual recognition of their conformity.
The Products covered by this Declaration
The products covered by this declaration are the SmartNode 1000 and 2000 series devices.
The Basis on which Conformity is being Declared
The products identified above comply with the requirements of the above EU directive by meeting
the following standards:
•
Safety Compliance: EN 60950 (Edition 1997, for SN2400: Edition 2001)
•
EMC Compliance: EN 55022 (Edition 1998), EN 55024 (Edition 1998)
additionally for SN2400 : EN55022 A1 (Edition 2000), EN55024 A1 (Edition 2001)
•
ISDN Terminal Equipment Requirements (BRI): ETS TBR3 (Edition 1999)
•
ISDN Terminal Equipment Requirements (PRI): ETS TBR4 (Edition 1999)
The CE mark was first applied in 2000.
Inalp Networks AG
Meriedweg 7
CH-3172 Niederwangen, Switzerland
Hardware Installation Guide, Revision 3.11
Summary of Contents for SmartNode 1000 Series
Page 2: ......
