Inalp Networks SmartNode 1000 Series, Hardware Installation Manual

Page: 23 / 73

SmartNode SN2400 Hardware Description 23
4 SMARTNODE SN2400 HARDWARE
DESCRIPTION
The SN2400 is a powerful multi-service access device. The 19in aluminum chassis can be rack-
mounted, and provides four expansion slots for interface cards. The SN2400 complies with all
relevant EU directives.
4.1 Physical Description
•
Chassis W/H/D 440 / 42 / 265 mm
•
Weight 1650g
•
CPU Motorola MPC750 @ 333 MHz
•
Memory 32 MB SDRAM, up to 128MB SO-DIMM
•
Flash 8 MB
•
Power dissipation 30 W, fully loaded interface card (IC) slots, without internal 48V (or 38V)
Line Power Module PM-48V-int (or PM-38V-int)
•
Power supply AC 100 - 240 V, 50/60 Hz, max. 1.0A or DC 48V, max. 2A
4.2 Front Panel
The front view of the SmartNode 2400 is depicted in Figure 4-1 below.
Figure 4-1: SmartNode SN2400 Front View
•
Three front LEDs (’PWR’,’RUN’, and ’ACT’) indicate the status of the device.
See Chapter 11, “Led Indications”, for detailed information on the LED states.
4.3 Rear Panel
The rear view of the device is depicted in Figure. There are four expansion slots for optional interface
cards, and four board-mounted sockets. Two LEDs (’Link’, ’100Mb/s’) for each of the Ethernet
interfaces indicate their status. See Appendix A for cabling connections and pin out data.
Figure 4-2: SmartNode SN2400 Rear View
4.4 Expansion Slots
Four slots, labeled SLOT 1 - SLOT 4, accept different PMC interface cards to integrate voice and data
over IP networks. The interface cards and their ports are described individually later in this Guide.
4.5 On-Board Ports
Two motherboard-mounted network interfaces are available for use, independently of those, which
are available with interface cards mounted in SLOT 1 - SLOT 4. The motherboard-mounted ports are
tabulated in below. The Port column of the table shows the port’s label and the interface type.
Hardware Installation Guide, Revision 3.11