BEFORE USE
9
10
BEFORE USE
20 inches
or more
1.
1.
1.
2.
Remote Control Holder Cap
Remote Control Stand Attachment Unit
Chair
Guide
Screw
L-shaped
Wrench
Tighten
Loosen
16 inches
or more
1.
2.
Chair Armrest
Lower Arm Unit
Plug
Jack
Slide Guide
Tighten
Loosen
BEFORE USE
How To Attach Remote Control Stand
1. Align the guide of the remote control
stand to the armrest hole on the right
of the chair and fix in place with the-
screw using the L-shaped wrench provi-
ded.
2. Place the remote control holder cap on
until it clicks into place.
Installation
Allow at least 20 inches clearance at the back and 16 inches in front of the chair lest the seat back should hit
a wall or object while reclining.
This product is shipped with the reclining seat back in its fully reclined position and the lower arm units
unattached. Be sure to raise the seat back to its fully upright position and set the lower arm units, referring
to "How To Attach Lower Arm Units".
Do not expose the chair to sudden bursts of heat. If the room where the chair is to be used is cold, turn the heat up
slowly. If the chair is moved from a cold place into a heated room, wait one hour before using the chair.
→
Condensation could occur in moving parts of the chair, which may compromise performance.
To avoid damaging floor surfaces and to cut down on the
noise of the chair, it may be better to install the chair on
a carpeted surface or to lay a piece of carpet under the
chair (Do not use electric blanket).
The chair is very heavy, so please be careful when
unloading it so as not to damage floor surfaces.
Install the chair at least 40 inches away from TVs, radios,
and/or other audio or video equipment. Noise from these
devices can cause problems.
Do not use in areas of high humidity like bathrooms
or saunas.
Only install on a flat, level surface.
Do not use in areas of high debris or dust content. Do
not use where the ambient temperature is 100
°
F or more.
Do not install the chair where it can come into contact
with direct heat, such as direct sunlight or radiator.
Caution
2. Turn on the main POWER switch on the back
of the chair. A text message should appear
on the remote control display screen.
Main Power Connection
1. Plug the power cord into the connector outlet
located at the back of the chair first.
Then plug the other end into the wall outlet.
* If the rollers have stopped in mid-massage, turning the main POWER switch ON again will reset the rollers to the Starting Posi-
tion (upper part of seat back). The chair will then turn itself off.
Caution
Before plugging the power cord into the wall outlet, make sure that the main POWER switch
is set to OFF.
Make sure that the plugs on the power cord are inserted fully into the connector and outlet.
Before using the chair for the first time, turn on all the power switches in order as indicated
in this manual to check that the chair is operating properly.
How To Attach Lower Arm Units
1. Align the slide guide of the lower arm units with the
armrest attachment portion of the chair before inserting.
2. Fully tighten the fixing screw after the unit
slide guide is in place.
Do not forcibly attach the lower arm units to the chair armrest. Insert the plug on the unit into the chair's jack
slowly and steadily.
Jack
Plug
Microphone Attachment Unit
Microphone
Cap
1.
2.
1. Insert the microphone/speaker into
attachment unit as illustrated.
2. Insert the microphone plug into the
jack on the backside of the
attachment unit. Place the cap on
the end of the microphone/speaker.
How To Install Microphone/Speaker
The lower arm units could slip off during operation if the screw is not properly fixed. Be
sure to tightly fix the screw.
Caution
Speaker
