SDI SOURCE
This field is used to identify connected camera. Currently, only ARRI cameras are supported. More
camera vendors will be available via firmware update.
SETUP
Bottom right corner of the ScreenPort user interface contains TOOLS/SETUP button. Switching this
button to setup mode reveals additional controls.
DEVICE CONTROL
Tap the BITRATE field to select the quality of the encoder output. Lower bitrate is useful for wireless
streaming, but if you intend to use wired connection, higher bitrates are available to provide better
image quality. You can further control encoder by setting it to constant (CBR) or variable (VBR)
bitrate. NETWORK field is used to connect to existing Wi-Fi network.
MUTE
Live audio can be turned off using MUTE LIVE button. Use MUTE DISK to mute playback audio.
Muting live audio will not affect audio recording.
NETWORK
Tap the NETWORK field to access Wi-Fi and Access Point controls. Enable Wi-Fi to connect to
existing Wi-Fi infrastructure. To create a new Wi-Fi network for client devices to connect to, enable
Access Point instead.
When enabled through the ON/OFF switch, the Wi-Fi section expands to show available Wi-Fi
networks. Allow a few seconds for scanning to complete after enabling. Tap a network to connect
and enter the Wi-Fi password if prompted. The connected Wi-Fi network is shown with a
checkmark on the right side.
When Access Point is enabled, Wi-Fi will automatically turn off. The Access Point section will
expand to show additional settings. To edit a setting, tap the corresponding row.
To change the access point password, tap the SSID field. This will open a dialog where you can set
both SSID and password. To change the SSID only while keeping your current password, leave the
password field blank.
ADVANCED NETWORK SETTINGS
To set a manual IP address for your ScreenPort device’s Ethernet or Wi-Fi interface, tap the MORE
button to reveal Advanced Network Settings. Tap the corresponding Configure IP row and set the
mode to Manual. When set to Manual, you can edit the IP address, subnet, router, and DNS fields by
tapping any of them.
AUDIO SETTINGS
Tap MORE button to open Audio Settings popover. If your SDI source is using audible timecode, you
can set TC Channel to Left or Right to mute it.
July 30, 2021
SCREENPORT SDI+ USER GUIDE
8
