QTAKE MONITOR APP
ScreenPort SDI+ device can be operated using the QTAKE Monitor application. When connected to
iOS device, ScreenPort SDI+ will be automatically detected by the application. Basic functionality
for monitoring, recording and playback is described below.
CREATE PROJECT
QTAKE Monitor is a client application that connects to QTAKE Server. After existing QTAKE project is
downloaded into QTAKE Monitor, the app can be used as a standalone monitor/recorder without
connection to server. Once QTAKE Monitor is re-connected, it will sync media and metadata back
into QTAKE ecosystem.
SELECT SDI INPUT
QTAKE Monitor can display up to 4 views and each view can display different content. In order to set
the active view to SDI input, tap the button in the top right corner and select ScreenPort SDI+. If
the device is not listed, refer to troubleshooting page.
RECORD SDI INPUT
When the view is in the LIVE mode, you can tap the bottom middle part of the SDI view to initiate
recording session. Incoming video and audio signal will be recorded into a media file. Tap the
bottom middle part of the view again to finish recording. In addition to manual recording, some
cameras support SDI record flags that can be used to initiate automatic recording. To set the
ScreenPort SDI+ to auto-record mode, please refer to Device Settings section.
SET IN/OUT RANGE
Each clip in QTAKE Monitor can have multiple ranges to allow only selected parts of the media file
to be played back. Use IN and OUT buttons to set the desired range during recording or playback.
PLAYBACK
Tap the REPLAY button in the top bar to play the last recorded clip. Tap the BROWSE button to open
the clip browser and select the clip to be loaded into active view. View mode will change from LIVE
to DISK. Tap the bottom middle part of the active view in the DISK mode to initiate playback. Tap
the top middle part of the view to switch between two playback modes: using ranges or ignoring
ranges. Tap the top left or right view corner to skip to previous or next range. To move the playhead
frame-by-frame, tap the bottom left or right corner.
For more details about advanced functionality please refer to
.
FIRMWARE UPDATE
Firmware update of the ScreenPort SDI+ is a simple procedure. To update your ScreenPort
firmware, launch the ScreenPort app on an iPhone or iPad connected to the internet, then connect
your ScreenPort device via USB. ScreenPort application will notify you if there is a newer version of
the firmware available. If you proceed with the update process, new firmware will be downloaded
July 30, 2021
SCREENPORT SDI+ USER GUIDE
9
