5
INSTALLATION
For transport purposes, units are sent partially disassembled
– hence some assembly by the user is required. The
following parts are included with each unit:
GardenMate 20
- Handle Assembly
- Battery
- Wheel (x2)
- Tank, Frame & Hose
- Spray gun Lance
-
Owner’s Manual
- Battery Cable
- 2 x Washers
- 2 x R-Clips
- 1 x M5x25 Screw
- 1 x M5x30 Bolt
NOTE
Exploded parts diagrams of the unit can be found at the end of this manual.
GardenMate models are supplied with 12V batteries. If the unit you have purchased is supplied with a battery,
please read the following section carefully.
INSTALLING THE BATTERY
The standard battery fitted is a sealed lead-acid type rated at 12 Volts 10 Ampere-Hours. The battery is shipped in
a charged state. For maximum life the battery must be serviced in accordance with the following instructions.
Failure to comply with these instructions will result in premature failure of the battery.
Charging:
Charge the battery with a current as described in the table below. If using a manual charger the charger must be
monitored during the charging process. The battery charger should be disconnected when the charging has been
completed. Spray switch must be in the ON position in order for the charging circuit to be completed.
Place the battery in the recess or bracket on the unit. Using the supplied battery cable, connect the black wire to
the negative (-) terminal on the battery. Connect the red wire to the positive (+) terminal on the battery. Join the
female 2-pin connector from the switch to the male connector on the pump.
Summary of Contents for Gardenmate 20
Page 10: ......