TM
Instruction manual
www.imv-imaging.com | 19
The battery can be charged in the charging dock, powered by a standard outlet. It can also be
connected in the carry case for in-car charging.
7. Charging
A fully discharged battery should be fully
charged within 5.5 hours. While in a good
condition, the battery run time will be 5 hours
(assuming 50% idle time between scans).
Scanner will enter low power mode when idle.
The Li-ion cells used in the battery pack do
not suffer from the ‘Memory effect’. For
optimal battery longevity, avoid letting the
battery run completely down and recharge at
approximately 20 Celsius/68 Fahrenheit.
Electrical connection to the power pack is
through the gold pads on battery and scanner.
Power pack output is protected but care
should be taken to prevent short circuiting the
gold connector pins and pads.
LED sequence
One blue flashing
Charging, charge level
below 33%
First LED solid blue
Second LED lashing
blue
Charging, charge level
below 66%
First and second LEDs
solid blue, third LED
flashing blue
Charging, charge level
below 100%
All LEDs solid blue – fully
charged.
Fully charged
All LEDs flashing yellow
Temperature is too high
(more than 45 Celsius, 113
Fahrenheit) for safe charging
All LEDs flashing blue
Temperature is too low (less
than 0 Celsius, 32 Fahrenheit)
for safe charging.
3rd LED
1st LED
2nd LED
!
Warning:
To reduce the risk of burns, fire, electric
shock, or injury to persons an appliance
should never be left unattended when
plugged into mains or 12 V cigarette
lighter.
