12
13
4 Operation
4.1 ON/OFF switching
With the ON/OFF button (pos. 1) the wipers can be switched on. When pressing
this button once, an internal test is carried out. The wipers will start in the
default setting and the LED’s above the individual wiper buttons (pos. 3) will
illuminate. The LED next to the ON/OFF button (pos. 1) will stay illuminated as
long as the panel is ON. When this button is pressed again, all wipers will park
and stop.
4.2 Choice of wipers
When pressing one of the wiper buttons on pos. 2 each wiper can be switched
ON and OFF individually. The LED’s above these buttons (pos. 3) indicate which
wipers are activated. Switching ON a wiper when the others are already
operating may cause a short delay of the other wipers. This is to synchronise
the operation
4.3 Continuous mode
To activate the continuous mode in low speed, press the button on pos. 4 until
LED’s A, B, C and D on the LED indicator bar (pos. 6) are illuminated. The wipers
will run synchronized. Press once more on the button on pos. 4 and the
continuous high speed mode is activated. All five LED’s in the LED bar (pos. 6)
will be illuminated.
4.4 Intermittent mode
To activate the intermittent mode, press the button on pos. 5 until the required
delay setting is reached. The wipers will run synchronised in all intermittent
settings.
LED’s illuminated
Delay
Speed mode
1 LED: A
10 sec.
Intermittent
2 LED’s: A + B
5 sec.
Intermittent
3 LED’s: A + B + C
2,5 sec.
Intermittent
4 LED’s: A + B + C +D
low speed
Continuous
5 LED’s: A + B + C +D
high speed
Continuous
4.5 Wipe/wash program
This wiper control has a built in ‘smart’ wipe/wash program which can be
activated by pressing the wipe/wash button (pos. 7). When shortly pressing
this button, the standard program will be started:
• The pump or solenoid will be activated allowing water to be sprayed onto the
screen.
• After three seconds, all wipers will start to run in the low speed mode for a
period of four seconds. Water will still be sprayed.
• After four second, the water supply will be stopped and the wipers will run
for another three seconds.
• After the program has been completed, the wipers will go back to the setting
that was previously used.
Besides the standard wipe/wash program as described before, you can also
choose a personalised program. The available programs are visualised here:
Standard program:
press WASH button (pos. 7) once.
Personalised program:
keep WASH button (pos. 7) pressed.
As long as the wipe/wash program is active, the LED next to the WASH button
will be illuminated. After the wash program has ended, all active wipers will go
back to the setting that was previously used.
As a standard, the wipers are included in the wash program. However, a wiper
can be excluded from the program as follows:
• Press the button on pos. 4 or pos. 5 until LED’s A, B, C, D and E blink.
• Press the button of the wiper that needs to be excluded and the respective
LED will go off.
• Press ON/OFF button (pos. 1) to store the new situation in the memory.
To undo, follow the same steps and the respective LED will illuminate again.
3 seconds
4 seconds
3 seconds
Spray
Spray
Wipe
Wipe
3 seconds
unlimited
3 seconds
Spray
Spray
Wipe
Wipe