1.6 LED indicator bar
The LED’s on the indicator bar (pos. 6) indicate the following settings:
Intermittent modes:
Maximum delay (10 sec):
Illuminated LED: A
Medium delay (5 sec):
Illuminated LED’s: A + B
Minimum delay (2,5 sec):
Illuminated LED’s: A + B + C
Continuous mode:
Low speed:
Illuminated LED’s: A + B + C + D
High speed:
Illuminated LED’s: A + B + C + D + E
1.7 Individual wiper buttons
When pressing the individual wiper buttons (pos. 2), each wiper can be
switched ON and OFF individually. Please refer to paragraph 3.3 for the wiper
connections.
1.8 Declaration of conformity
This wiper control complies with the European requirements for
electromagnetic compatibility, as required from 89/366/EEC, 73/33/EEC and
EN60945 directives.
6
2 Installation
2.1 Dimensions touch pad
2.2 Installation of touch pad
The touch pad is to be fitted at a location that is within reach of the helmsman,
allowing ease of operation. Make sure that sufficient room is available for the
cables and the connectors. The required mounting hole for the touch pad is
79 x 80 mm. There should be at least 75 mm (3”) space available under the
front of the touch pad for the connection cable and plug.
The touch pad has four recessed mounting holes of 3,5 mm in diameter. They
allow easy and quickly fitting using stainless steel screws or the bolts and nuts
supplied.
7
E
B
A
C D
98
85
Ø3,5
100
82,5
78
79
26
14
75
35
Dimensions in mm
Wiper 1
Wiper 3
Wiper 5
Wiper 2
Wiper 4
Wiper 1
Wiper 2
Wiper 3
Wiper 4
Wiper 5