IMR® 2800
47
IMR Environmental Equipment, Inc.
Finish the measurement and charge the battery. If possible continue the measurement with the
unit connected to the AC.
Battery empty
The battery voltage is below10 V. This message will be printed and displayed.
The analyzer cannot be used at this point and will turn off automatically.
Connect the unit to the AC and once the battery has a minimal charge it can be operated while
connected to the AC.
T-int
6 oC / 43oF or T-O2
6 oC / 43oF
The internal temperature is too low for proper use.
Let the unit run until it is warmed up and then start a new calibration.
T-int > 50oC / 122oF or T-O2 > 50oC / 122oF
The internal temperature is too high for proper use.
Let the analyzer cool down and then start a new calibration.
xxx-sensor defect
xxx is a temperature sensor (T-Ni, T-Pr, T-int, T-O2).
A temperature sensor is defect or it is not connected. Check the connection.
Interface no CTS
RS 232 interface is not connected or the data transfer was not done properly.
Check the connection between the
IMR 2800
‚ and the PC.
If an interval output has been activated, it will be automatically turned off.
Memory full
The memory spaces are full.
Erase some measurements to store additional measurements.
