Immergas ZENITAIR MONO, Installation Manual

Page: 14 / 100

14 14
3
OPERATION
Remote Controller
FILTER RESET BUTTON
MODE BUTTON
MODE ICON
FILTER RESET ICON
AIR FLOW DIRECTION
ICON
SPEED ICON
BOOST ICON
SPEED BUTTONS
AIR FLOW DIRECTION
BUTTON
BOOST BUTTON
SPEED ICON
OFF BUTTON
K L
The unit is supplied with an infrared remote controller (K)
as standard, as well as its support base (L) which can be wall
mounted. A magnet keeps the controller attached to the base.
The controller is equipped with an LCD display to visualise the
setting to be transferred to the unit; anytime a touch button is
pressed, the setting shown on the LCD display is transferred to
the unit. The IR receiver (J fig. 1) is placed on the left side of
the ventilation unit: it is recommended to point the controller
towards the receiver when any setting needs to be transfered.
One remote controller can control more units.
To activate the remote controller it is necessary to insert two
AAA type batteries (not supplied).
Ventilation Unit
When switched on the unit emits a long acoustic signal.
Through the IR controller the following functionalities can be
activated/deactivated. When one setting is transferred to the
unit, a short acoustic signal is emitted and a green led flashes.