40
NOTE:
Only a maximum of 6 values can be stored in the list. Older values are removed from the list and are no longer
taken for the determination of the average value
In order to delete the measurement series, actuate the button „Down“
.
TIPP!
Within the operating mode „Average Value”, the
SONO-DIS will deliver a representative measurement
result for the volume of the material..
1.5 Operating Mode „Water Calculation“
In this operating mode, only the variable Moisture is measured. There will be up to six single values stored and
concluded to an average value. Out of this the water content per m³ is calculated. To get the correct water content
it is necessary to set up the density of the measured material.
The measurement is initiated by actuating the button „Measurement“
. Repeating this will add another
measurement value. The average water content will be calculated and displayed.
Number of selected Calibration
Density in kg/dm³
Individual Values of the Measurements
Residual Accumulator Capacity
Average of Water content in l/m³
In order to delete the measurement series, actuate the button „Down“
.
To set up the density of your material, actuate the button „Up“
. Then you will get the following screen in the
display:
Adjust the density of your material by actuating the
buttons „Up“
and „Down“
. Confirm your setting
by pressing the button “Measurement”
. You will
get back to the measurement screen. Leave the setting
without changing the density by pressing the button
„Settings“
.
