28/11/02-\\SERVER\TECNICO\-SNZ\0Sit\hVtf500shie.doc-Scheda Identificazione Codice Padre (mac.sott.etc...)-
13 di 62 pagine.
Pagina
n°-
13
the rear protection -pos.2/dr.RI0103- by loosing the side screw, unhook the locks of the coverband guard
protection -pos.3/dr.RI0103- and open it to be sure that the band ( " or blade " ) is against the pulley and it
is correctly put in the band guides head , specially the up pulley .
If necessary loosen a little the screw of the band stretcher-pos.4/dr.RI0103, to place again the band , then
close the both guard protections by locking the corresponding fixing parts.
Push the main switch -pos.8/dr.RI0102-, wait for some seconds that the panel - drawing RI0055- stabilizes
its workings, then push many times the pushbutton MODE -pos.10/dr.RI0055- until the LED light marked
with the "band" symbol -pos.6/dr.RI0055- is on.
If the LED flashes , it means that the band is not tensioned : screw the screw of the band adjuster -
pos.4/dr.RI0103- by using the proper spanner , until the LED will be continuinghly
flashing.
The procedure to change the blade after a change of pitch, wear and tear and break is the same one of the
above described procedure .In this case it will be necessary a careful cleaning of all points of connection
with the band.
In the following paragraph you will find the full controls list .