7 / 15
Nemo SX - Multifunction state module
Cat. N°:
SXMC02
5. GENERAL CHARACTERISTICS
(continued)
Link Functionality:
. This function allows you to link two Nemo SX modules to create automatic actions that, once programmed, can run independently without a
connection to a manager is needed.
The basic rule is the link between an event (circuit breaker that trip, a threshold exceeded, etc.) and an action accordingly (signalling, opening
of a circuit by motorized control or contactor, etc.).
Possible associations are:
Action module
Event
generator
Command:
SXM0C1
State:
SXMC02
Measure:
SX3M63, SXMM63, SXMT63,
SXMT125, SXMMT5, SXMR02,
SXMR04, SXMR06, SXMR08
Only with the module configured
(locally or remotely) as shown:
State:
SXMC02
It’s enough to configure the module
(locally or remotely) as ˝Slave˝
Note:
- association can only be of type 1 to 1 (1 event and 1 action).
- modules already associated cannot be used for other associations.
- all the configuring procedure will be done with the Configuration Software (available online for free).
[For more details refer to the Installation Manual
of Nemo SX Configuration software]
Modules compatible with “Link Functionality” feature: firmware versions and production date:
Cat n°
Firmware version
Production date indicated on the label
sticked on the side of the module
SX3M63
all firmware versions
any production date
SXMM63
ver. ≥ 2.0.1
date ≥ 18W49
SXMT63
ver. ≥ 2.0.1
date ≥ 18W49
SXMT125
all firmware versions
any production date
SXMMT5
ver. ≥ 2.0.1
date ≥ 18W35
SXMR02
all firmware versions
any production date
SXMR04
all firmware versions
any production date
SXMR06
all firmware versions
any production date
SXMR08
all firmware versions
any production date
SXMC02
ver. ≥ 2.0.2
date ≥ 18W49
SXM0C1
ver. ≥ 3.0.2
date ≥ 18W39
SXV01
ver. ≥ 2.0.4
date ≥ 18W38
SXI485
ver. ≥ 3.0.8
date ≥ 18W31
Technical data sheet: IDP000169EN_04
Updated: 30/09/2020
Created: 31/08/2017
